3. Ringing with others

Rounds

Once you have learned to handle a bell you will be ready to ring rounds with other ringers. You will be aiming to ring with even, rhythmic striking without any “clips” or “gaps”.

In rounds the bells are rung in a sequence of descending notes starting with the treble and finishing with the tenor in a row [a sequence in which every bell strikes once]. The gaps between the bells should all sound even:

1 2 3 4 5 6

In rounds the 1 [treble] rings first [or leads]. The 6 [tenor] rings last, is “ringing behind” or is “covering”. The 3 is ringing in 3rd place [a place is the position in which the bell sounds or strikes in the row]. The term 'tenor' is applied to the bell of deepest tone in any peal of bells but is also used to denote the last bell in the set being rung. For example, many 12 bell towers have a second number two bell tuned to a semitone higher than the normal bell. This allows for a light 8 to be rung on the front 8 of the 12 with this semitone bell instead of the normal number 2. Other combinations are possible in towers with more bells.

One aspect of ringing rounds that is variable is the gap between successive bells as the number of bells increases. For example, the gap between the 2nd and 3rd bell when ringing 12 is much smaller than if the same two bells were ringing rounds on 6.

Bell control and keeping in the right place in rounds

To ring rounds successfully you need to be able to change the speed of your ringing at both handstroke and backstroke. At first your teacher will tell you to ring quicker or slower to keep in time with the other ringers. Over time you will develop your own listening skills so that you can do this yourself.

If you need to ring more quickly

You will need to ring below the balance so that the bell moves through a smaller arc. Slow or check the sally or backstroke so the bell does not rise as high. You may need to:

  • Check the sally and don’t let it rise so high at handstroke.
  • Take some rope in (shorten the tail-end) at backstroke.
  • Put more weight on the stroke to keep the bell up after you have checked the stroke.
If you need to ring more slowly

You need to ring at the balance so that the bell moves through a complete arc. Let the sally or backstroke rise to (or nearer) the balance. You may need to:

  • Put more weight into the previous stroke.
  • Let the sally rise a little higher at handstroke.
  • Let some rope out (lengthen the tail-end).
Ringing with others for the first time

When all the ringers have taken hold of their ropes the treble ringer will say “Look to”, or “Look to the treble”. This is a warning that ringing is about to start. You should then put some tension on the sally to pull the bell off the stay towards the point of balance in preparation for an accurate pull off.

The treble ringer will then say “Treble’s going” (and will check that the ringers have looked to) followed by “She’s gone” as they pull the treble off. You should then pull off your bell in rounds immediately after the bell you are following.

To stop the ringing the conductor will call “Stand” or “Stand next time” when the treble is ringing at handstroke. You should ring that handstroke, the following backstroke and set the bell on the following handstroke.

Bell control exercises

The Method Toolboxes contain plenty of interesting and challenging exercises for improving bell control. If you're a ringing teacher have a look at the Method Toolboxes for teachers.